AFNI program: 3dZcat

Output of -help


Usage: 3dZcat [options] dataset dataset ...
Concatenates datasets in the slice (z) direction.  Each input
dataset must have the same number of voxels in each slice, and
must have the same number of sub-bricks.

Options:
  -prefix pname = Use 'pname' for the output dataset prefix name.
                    [default='zcat']
  -datum type   = Coerce the output data to be stored as the given
                    type, which may be byte, short, or float.
  -fscale       = Force scaling of the output to the maximum integer
                    range.  This only has effect if the output datum
                    is byte or short (either forced or defaulted).
                    This option is sometimes necessary to eliminate
                    unpleasant truncation artifacts.
  -nscale       = Don't do any scaling on output to byte or short datasets.
                    This may be especially useful when operating on mask
                    datasets whose output values are only 0's and 1's.
  -verb         = Print out some verbositiness as the program proceeds.
  -frugal       = Be 'frugal' in the use of memory, at the cost of I/O time.
                    Only needed if the program runs out of memory.
                    Note frugality cannot be combined with NIFTI output

Command line arguments after the above are taken as input datasets.

Notes:
* You can use the '3dinfo' program to see how many slices a
    dataset comprises.
* There must be at least two datasets input (otherwise, the
    program doesn't make much sense, does it?).
* Each input dataset must have the same number of voxels in each
    slice, and must have the same number of sub-bricks.
* This program does not deal with complex-valued datasets.
* See the output of '3dZcutup -help' for a C shell script that
    can be used to take a dataset apart into single slice datasets,
    analyze them separately, and then assemble the results into
    new 3D datasets.
* Also see program 3dXYZcat for a version that can catenate along
    the x and y axes as well (with some limitations).

++ Compile date = Mar 28 2024 {AFNI_24.0.18:linux_ubuntu_16_64}


This page auto-generated on Thu Mar 28 19:35:48 EDT 2024